Physioex cell transport mechanisms and permeability answers. PhysioEx Exercise 1 Activity 1 2022-11-03

Physioex cell transport mechanisms and permeability answers Rating: 8,6/10 1938 reviews

Cell transport mechanisms and permeability refer to the ways in which substances, such as nutrients, ions, and waste products, enter and exit cells. These mechanisms are important for maintaining homeostasis within the cell and the body as a whole. In this essay, we will explore the different types of cell transport mechanisms, including passive transport and active transport, and discuss how permeability plays a role in these processes.

Passive transport is the movement of substances across the cell membrane without the use of energy. There are three types of passive transport: diffusion, osmosis, and facilitated diffusion.

Diffusion is the movement of particles from an area of high concentration to an area of low concentration. For example, oxygen molecules will diffuse from a region of high concentration in the air to a region of low concentration in the body's tissues.

Osmosis is the movement of water molecules from an area of high concentration to an area of low concentration through a semi-permeable membrane. For example, if a cell is placed in a solution with a higher concentration of solutes, water will move out of the cell through the semi-permeable membrane in an attempt to equalize the concentration on both sides.

Facilitated diffusion is the movement of molecules or ions through specific protein channels in the cell membrane. These protein channels are selective, meaning they only allow certain substances to pass through. For example, glucose molecules can pass through protein channels in the cell membrane via facilitated diffusion, but larger molecules such as proteins cannot.

Active transport is the movement of substances across the cell membrane using energy in the form of ATP (adenosine triphosphate). Active transport requires the use of protein pumps, which use ATP to move substances against their concentration gradient. For example, the sodium-potassium pump uses ATP to transport sodium ions out of the cell and potassium ions into the cell, helping to maintain the proper balance of ions within the cell.

Permeability refers to the ability of a substance to pass through a membrane. The permeability of a membrane can be affected by various factors, such as the size and charge of the substance, the presence of specific protein channels or pumps, and the overall structure of the membrane.

In summary, cell transport mechanisms and permeability play a crucial role in maintaining homeostasis within cells and the body as a whole. Passive transport, including diffusion, osmosis, and facilitated diffusion, occurs without the use of energy, while active transport requires energy in the form of ATP. The permeability of a membrane can be affected by various factors and plays a role in the movement of substances across the membrane.

PhysioEx Exercise 1 Activity 1

physioex cell transport mechanisms and permeability answers

As the run progresses, the concentrations of the solutes will change in the windows next to the two beakers. Would pressure be generated if solute concentrations were equal on both sides of the membrane? If so, which solution was generating the pressure? Because the molecular weight exceeded the highest MWCO membrane, thus being too large to pass through. Activity 3: Investigating Graded Muscle Response to Increased Stimulus Intensity Questions:? Lowering the voltage decreases the total force produced. The higher number of carriers the quicker it reaches equilibrium Does the diffusion rate of Na? Does the membrane MWCO affect filtration rate? Because no diffusion took place. Correct Part B For solutes that move by simple diffusion, which of the following does NOT affect the rate of simple diffusion across a membrane? The size of the powdered charcoal was too large How can the body selectively increase the filtration rate of a given organ or organ system? No What is the mechanism of the Na? The muscle cell is biochemically preparing for contraction, including events such as the release of calcium from the sarcoplasmic reticulum, and the movement of the chemicals of contraction within the cell; includes all biochemical events beginning with acetylcholine binding to the sarcolemma through the beginning of cross-bridge binding.

Next

PhysioEx_ Cell Transport Mechanisms and webapi.bu.edu

physioex cell transport mechanisms and permeability answers

Smooth, sustained force at 2 gms can be produced at approximately 1. Would pressure be generated if you had 9 mM glucose on one side of a 200 MWCO membrane and 9 mM NaCl on the other side? Because the ATP was used up in the first 3 min. . Yes, the larger the MWCO the faster the filtration Does the amount of pressure applied affect the filtration rate? No, Both are equa. ACTIVITY 2: Simulating Dialysis What happens to the urea concentration in the left beaker the patient? Why or why not? No ACTIVITY 4: Osmosis Did you observe any pressure changes during this experiment? Yes Does the amount of solute transported across the membrane change with an increase in carriers or pumps? If so, which solution was generating the pressure? ACTIVITY 5: Filtration What were the results of your initial membrane analysis? As long as stimuli are delivered relatively close together, the active force produced by subsequent stimuli slightly increases for the first few stimuli. Check all that apply. Plasma vesicles If you put the same amount of glucose in the right beaker as in the left, would you be able to observe any diffusion? Explain the relationship between solute concentration and osmotic pressure.

Next

Answers PhysioEx 8.0 Cell Transport Mechanisms and Permeability

physioex cell transport mechanisms and permeability answers

Correct Part D Through which membrane s would sodium chloride diffuse? The total force production is even greater when stimuli are delivered more rapidly. If not, which one s did not? Because diffusion took place. Manipulating both allows the muscle to produce smooth force at any desired level. As more voltage is delivered to the whole muscle, more muscle fibers are activated and total force produced by muscle is increased. Yes Is one solute more affected than the other? Activity 4: Investigating Treppe Questions:? As the stimulus rate is increased, the active force produced by the muscle also increases.

Next

physioex cell transport mechanisms and permeability answers

Yes, the greater the pressure, the faster the filtration Did all solutes pass through all the membranes? No, powdered charcoal Why? They are directly proportional, if the solute concentration increases the osmotic pressure will increase. It is reduced to 50%. Does diffusion allow osmotic pressure to be generated? Smooth, sustained force at 3 gms can be produced at approximately 1. The greater frequency of stimulatin results in a greater force generated. No it does not Does the amount of ATP added make any difference? What is the molecular weight of Na?? Yes, 50, 100, and 200 MWCO Why? Yes Activity 2: Determining the Latent Period Questions:? Would pressure be generated if you had 9 mM albumin on one side of a 200 MWCO membrane and 9 mM NaCl on the other side? Complete the Experiment and then answer the Post-lab Quiz questions to the right. The peak force produced in the second contraction is greater than that produced by the first stimulus.

Next

physioex cell transport mechanisms and permeability answers

If so, in which beaker s , and with which membranes? The rate will slow down markedly, then stop before completed. No Does being unable to observe diffusion necessarily mean that diffusion is not taking place? In the L beaker with the 20 MWCO Membrane, the pressure went up. Yes, the albumin would generate the pressure, because it does not diffuse. PhysioEx: Cell Transport Mechanisms and Permeability Due: 11:59pm on Wednesday, January 6, 2021 You will receive no credit for items you complete after the assignment is due. Increasing the stimulation rate causes smoother force production. If so, with which membrane s? Activity 5: Simulating Active Transport Questions:? No, because both glucose and NaCl are diffusible with a 200 MWCO membrane.

Next

physioex cell transport mechanisms and permeability answers

. . . . . . .

Next

physioex cell transport mechanisms and permeability answers

. . . . . .

Next

physioex cell transport mechanisms and permeability answers

. . . . . . .

Next

physioex cell transport mechanisms and permeability answers

. . . . . .


Next

physioex cell transport mechanisms and permeability answers

. . . . . .

Next